Cisco ASA5500-HW - Hardware Accessory Kit Network Device Installation Guide download pdf (Page 79)

C-3

Cisco ASA 5500 Series Hardware Installation Guide

OL-10089-01

Appendix C Cable Pinouts

RJ-45 to DB-9

Examine the sequence of colored wires to determine the type of RJ-45 cable, as follows:

• Straight-through—The colored wires are in the same sequence at both ends of the cable.

• Crossover—The first (far left) colored wire at one end of the cable is the third colored wire at the

other end of the cable.

RJ-45 to DB-9

Table C-2 lists the cable pinouts for RJ-45 to DB-9 or DB-25.

MGMT 10/100/1000 Ethernet Port

The MGMT 10/100/1000 Ethernet port is an Ethernet port with an RJ-45 connector. You can use a

modular, RJ-45, straight-through UTP cable to connect the management port to an external hub, switch,

or router.

Table C-3 lists the cable pinouts for 10/100/1000BASE-T Management Port Cable Pinouts (MDI).

Table C-1 RJ-45 Rolled (Console) Cable Pinouts

Signal Pin Pin Pin

- 18-

- 27-

- 36-

- 45-

- 54-

- 63-

- 72-

- 81-

Table C-2 Cable Pinouts for RJ-45 to DB-9 or DB-25

Signal RJ-45 Pin DB-9 Pin

RTS 8 8

DTR 7 6

TxD 6 2

GND 5 5

GND 4 5

RxD 3 3

DSR 2 4

CTS 1 7

1 2 ... 74 75 76 77 78 79 80 81 82

No comments

Cisco ASA5500-HW - Hardware Accessory Kit Network Device Installation Guide Page 79