Cisco ASA5500-HW - Hardware Accessory Kit Network Device Installation Guide download pdf (Page 32)

2-4

Cisco ASA 5500 Series Hardware Installation Guide

OL-10089-01

Chapter 2 ASA 5505

Installing the Chassis

a. Ethernet ports

Step 1 Connect Port 0, the outside Ethernet port, to the public network, that is, the Internet:

Note By default, switch port 0/0 is the outside port. If needed you can change the inside and outside

ports assignments later.

Step 2 Connect your network devices with an Ethernet cable to one of the inside ports (numbered 1 through 7).

If you are connecting any PoE devices, connect them to one of the switch ports that support PoE (ports

numbered 6 and 7).

Step 3 Check the LINK LED to verify that the network devices have basic connectivity to the ASA 5505 on one

of the inside ports (numbered 0 through 7). When connectivity is established, the LINK LED on the front

panel of the ASA 5505 lights up solid green.

Figure 2-3 Connecting Cables to Network Interfaces

Step 4

Connect the power cord to the security appliance and plug the other end to the power source. For

information on powering on the chassis, see the “Powering on the ASA 5505” section on page 2-5

1 RJ-45 Ethernet ports 2 RJ-45 connector

153646

Status

Security

Services

Card Slot

console

reset

power

VDC

7 POWER over ETHERNET 6

543210

Cisco ASA SSC-05

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 81 82

No comments

Cisco ASA5500-HW - Hardware Accessory Kit Network Device Installation Guide Page 32