Cisco ASA5500-HW - Hardware Accessory Kit Network Device Installation Guide download pdf (Page 56)

A-6

Cisco ASA 5500 Series Hardware Installation Guide

78-17374-01

Appendix A Installing and Replacing the SSM

Installing and Replacing the 4GE SSM

Installing the SFP Module

Note The following is supported on the ASA 5510, ASA 5520, ASA 5540, and ASA 5550.

To install the SFP module in the 4GE SSM, perform the following steps:

Step 1 Line up the SFP module with the port and slide the SFP module into the port slot until it locks into

position as shown in Figure A-4.

Figure A-4 Installing an SFP Module

Caution Do not remove the optical port plugs from the SFP until you are ready to connect cabling.

Step 2 Remove the Optical port plug; then connect the network cable to the SFP module.

Step 3 Connect the other end of the cable to your network. For more information on connecting the cables, see

“Connecting the Interface Cables” section on page 2-3.

Caution The latching mechanism used on many SFPs locks them into place when cables are connected. Do not

pull on the cabling in an attempt to remove the SFP.

1 Optical port plug 2 SFP port slot

3 SFP module

132985

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 81 82

No comments

Cisco ASA5500-HW - Hardware Accessory Kit Network Device Installation Guide Page 56