Cisco ASA5500-HW - Hardware Accessory Kit Network Device Installation Guide download pdf (Page 43)

3-9

Cisco ASA 5500 Series Hardware Installation Guide

78-17374-01

Chapter 3 ASA 5510, ASA 5520, ASA 5540, and ASA 5550

Installing the Chassis

a. Management port

The adaptive security appliance has a dedicated management interface referred to as the Management0/0

port. The Management0/0 port is a Fast Ethernet interface with a dedicated port used only for traffic

management.

Note You can configure any interface to be a management-only interface using the management-only

command. You can also disable management-only mode on the management interface. For more

information about this command, see the management-only command in the Cisco Security

Appliance Command Reference.

–

Connect one RJ-45 connector to the Management0/0 port, as shown in Figure 3-9.

–

Connect the other end of the Ethernet cable to the management port on your computer or

network device.

Figure 3-9 Connecting to the Management Port

1 Management port 2 RJ-45 to RJ-45 Ethernet cable

USB2

USB1

LNK SPD

MGMT

92684

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 81 82

No comments

Cisco ASA5500-HW - Hardware Accessory Kit Network Device Installation Guide Page 43