Cisco ASA5500-HW - Hardware Accessory Kit Network Device Installation Guide download pdf (Page 60)

A-10

Cisco ASA 5500 Series Hardware Installation Guide

78-17374-01

Appendix A Installing and Replacing the SSM

Installing and Replacing the SSM

Figure A-7 Removing the Screws from the Slot Cover

Step 4

Insert the SSM into the slot opening as shown in Figure A-8.

Figure A-8 Inserting the SSM into the Slot

Step 5

Attach the screws to secure the SSM to the chassis.

Step 6 Power on the adaptive security appliance.

Step 7 Check the LEDs. If the SSM is installed properly the POWER LED is solid green and the STATUS LED

flashes green.

Step 8 Connect one end of the RJ-45 cable to the port and the other end of the cable to your network devices. For

more information, see Figure 3-15.

Replacing an SSM

Note The following is only supported on the ASA 5510, ASA 5520, and ASA 5540.

To replace an existing SSM, perform the following steps:

Step 1 Enter the hw-mod mod 1 shut command in privileged EXEC mode. Verify if the module is down by

checking the LEDs.

Step 2 Locate the grounding strap from the accessory kit and fasten it to your wrist so that it contacts your bare

skin. Attach the other end to the chassis.

Step 3 Remove the two screws (as shown in Figure A-7) at the left rear end of the chassis, and remove the slot

cover.

Step 4 Remove the SSM. Set it aside.

Step 5 Replace the existing card by inserting the new SSM through the slot opening.

119642

MGMT

USB2

USB1

POW

STATUS

FLASH

VPN

ACTIVE

119643

MGMT

USB2

USB1

POW

STATUS

FLASH

VPN

ACTIVE

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 81 82

Comments to this Manuals

No comments

Cisco ASA5500-HW - Hardware Accessory Kit Network Device Installation Guide Page 60

Comments to this Manuals

Related products and manuals for Chassis components Cisco ASA5500-HW - Hardware Accessory Kit Network Device