Cisco CX-FEIP-1TX= Installation and con?guration User's Guide download pdf (Page 579)

PTP 800 Series User Guide Managing alarms and events

phn-2513_004v000 (Oct 2012)

7-27

SNMP Trap name Description Cause and action

dataPortFiberStatusT

rap

A problem has been detected

with the fiber interface on the

data Ethernet port.

The attribute

dataPotrtFiberStatus identifies

which problem has been

detected.

There are three possible

causes:

1) The fiber interface has

been installed but disabled

(because the license key does

not include fiber support).

2) The interface could not be

established even though a

fiber carrier was detected.

This could be due to a broken

TX fiber, or because the

interface is disabled at the

other end of the fiber link.

3) The interface could not be

established and no fiber

carrier is detected.

managementPortConf

igurationMismatchTr

ap

The detection of Ethernet

fragments (runt packets) on the

data Ethernet port when the link

is in full duplex operation.

This is probably due to a

configuration error such as

an auto-negotiation or forced

configuration mismatch.

managementPortDisa

bledWarningTrap

The Administrative Status of the

out-of-band management

Ethernet interface has disabled

Ethernet traffic.

The management Ethernet

port has been disabled

remotely by a management

system.

Note that the physical port

continues to operate but no

data is transmitted over it.

rFUStatusTrap A change of status of the RFU

has occurred.

The RFU Status indicates the

nature of the RFU fault.

A state of 'ok' indicates that

the RFU is fully operational,

although may not be

transmitting.

dataPortStatusTrap A change of state for the data

port has occurred.

The data port status has

changed – most significantly

to up or down

1 ... 578 579 580 ... 648

Comments to this Manuals

No comments