Cisco RPM-XF Specifications download pdf (Page 218)

100

101

5-8

Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches

Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005

Chapter 5 AXSM Command Reference

addcon

Add Connection—AXSM, AXSM-E, AXSM-32-T1E1-E, AXSM-XG

Adds a logical connection as an SPVC on a service module. The switch assigns a 20-octet NSAP address

to the slave endpoint, which is sent back to the master and uniquely identifies the endpoint on the

network. An AXSM front card can support a maximum of 64K SPVCs. This command does not apply

to SVCs or SVPs.

AXSM supports a maximum of 64K SPVCs. AXSME supports a maximum of 60K SPVCs–4K are

reserved.

The connection is either a dual-ended connection or a single-ended connection. For a dual ended

connection, you first add the endpoint at the slave-end switch. Upon successful addition of the slave

endpoint, the slave-end node generates a 20 octet NSAP address for that endpoint that is used at the

master endpoint. The slave endpoint identifier uniquely identifies the endpoint in the network, and you

must use this identifier when adding the master endpoint of a dual-ended connection. For a single-ended

connection, you add the connection only at the master end.

Note VS/VD cannot be enabled on the port with WFQ disable in SCT.

Warning

Changing connection parameters will result in a momentary loss of traffic.

Warning

Changing routing parameters will not take effect on the slave endpoint of a DAX connection.

Before Adding a Connection

Before you can add an SPVC, the following tasks must have been completed:

1. The switch must have a network controller (see the addcontroller command in the Cisco MGX

8800/8900 Series Command Reference, Release 5.2).

2. A physical line must be active. Use the upln command.

3. At least one logical port must exist on the active physical line. Use the addport command to create

the port. If necessary, modify the port through cnfport.)

4. At least one resource partition must exist on the logical port. Use addrscprtn or addpart. The

resource partition should be associated with the controller added in step 1.

5. Optionally, configure the version of the UNI by using the cnfpnportsig command at the PXM card.

UNI endpoints do not require signalling. However, although the default interface type is UNI, no

default exists for the version of UNI. Remember to up the PNNI port by using the uppnport

command at the PXM card.

Adding a Connection

Adding a connection requires you first to provision a slave endpoint. Subsequently, you again execute

addcon to provision a master endpoint. The master endpoint of the connection initiates the routing of

the call and can be viewed as the “calling” party. The slave endpoint is the called endpoint. The following

characteristics pertain to this master-slave arrangement:

1 ... 217 218 219 ... 688

Comments to this Manuals

No comments

Cisco RPM-XF Specifications Page 218

Comments to this Manuals

Related products and manuals for Networking Cisco RPM-XF