4-7
Cisco ONS 15454 SDH Troubleshooting and Maintenance Guide, R3.3
May 2002
Chapter 4 Maintenance
Database Backup and Restoration
Note The following parameters are not backed up and restored: node name, IP address, mask and gateway,
and IIOP port. If you change the node name and then restore a backed up database with different node
names, the circuits will map to the new node name. Cisco recommends keeping a record of the old
and new node names.
Procedure: Back up the Database
Step 1 Log into the CTC software.
Step 2 Click the Maintenance > Database tabs (Figure 4-3).
Figure 4-3 Backing Up the TCC-I Card database
Step 3
Click Backup.
Step 4 Save the database to the workstation hard drive or to network storage. Use an appropriate file name with
the file extension db, for example, “database.db.”
Step 5 Click Save.
Purpose This procedure backs up an ONS 15454 database.
Tools/Equipment Workstation configured for CTC software
Prerequisite procedures —
Required/As Needed As needed
On Site/Remote On Site
Comments to this Manuals