4-72
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 4 Configuring Virtual Contexts
Configuring Object Groups
• Click Next to deploy your entries and to add another entry to the Host Setting table.
Related Topics
• Configuring Object Groups, page 4-70
• Configuring Subnet Objects for Object Groups, page 4-72
• Configuring Protocols for Object Groups, page 4-73
• Configuring TCP/UDP Service Parameters for Object Groups, page 4-73
• Configuring ICMP Service Parameters for an Object Group, page 4-76
Configuring Subnet Objects for Object Groups
Use this procedure to specify subnet objects for a network-type object group.
Procedure
Step 1 Choose Config > Virtual Contexts > context > Security > Object Groups.
The Object Groups table appears, listing existing object groups.
Step 2 Choose the object group you want to configure subnet objects for and then click the Network Setting
For Object Group tab.
The Network Setting For Object Group table appears.
Step 3 Click Add to add an entry to this table.
Step 4 Choose one of the following:
• IPv4—A subnet object with an IPv4 IP address. In the IPv4 Address field, enter the IP address. In
the Netmask field, select the subnet mask for this subnet object.
• IPv6—A object with an IPv6 IP address. In the IPv6 Address field, enter the IP address. In the
Network Prefix Length field, enter the prefix length for this object.
Step 5 Do one of the following:
• Click Deploy Now to immediately deploy this configuration. This option appears for virtual
contexts.
• Click Cancel to exit this procedure without saving your entries.
• Click Next to deploy your entries and to add another entry to the Network Setting table.
Related Topics
• Configuring Object Groups, page 4-70
• Configuring IP Addresses for Object Groups, page 4-71
• Configuring Protocols for Object Groups, page 4-73
• Configuring TCP/UDP Service Parameters for Object Groups, page 4-73
• Configuring ICMP Service Parameters for an Object Group, page 4-76
Comments to this Manuals