4-73
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 4 Configuring Virtual Contexts
Configuring Object Groups
Configuring Protocols for Object Groups
Use this procedure to specify protocols for a service-type object group.
Procedure
Step 1 Choose Config > Virtual Contexts > context > Security > Object Groups.
The Object Groups table appears, listing existing object groups.
Step 2 Choose an existing service-type object group and then click the Protocol Selection tab.
The Protocol Selection table appears.
Step 3 Click Add to add an entry to this table.
Step 4 In the Protocol Number field, select the protocol or protocol number to add to this object group.
See Table 4-18 for common protocols and their numbers.
Step 5 Do one of the following:
• Click Deploy Now to immediately deploy this configuration. This option appears for virtual
contexts.
• Click Cancel to exit this procedure without saving your entries.
• Click Next to deploy your entries and to add another entry to the Protocol Selection table.
Related Topics
• Configuring Object Groups, page 4-70
• Configuring IP Addresses for Object Groups, page 4-71
• Configuring Subnet Objects for Object Groups, page 4-72
• Configuring TCP/UDP Service Parameters for Object Groups, page 4-73
• Configuring ICMP Service Parameters for an Object Group, page 4-76
Configuring TCP/UDP Service Parameters for Object Groups
Use this procedure to add TCP or UDP service objects to a service-type object group.
Procedure
Step 1 Choose Config > Virtual Contexts > context > Security > Object Groups.
The Object Groups table appears, listing existing object groups.
Step 2 Choose an existing service-type object group and then select the TCP/UDP Service Parameters tab.
The TCP/UDP Service Parameters table appears.
Step 3 Click Add to add an entry to this table.
Step 4 Configure TCP or UDP service objects using the information in Table 4-21.
Comments to this Manuals