4-76
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 4 Configuring Virtual Contexts
Configuring Object Groups
Configuring ICMP Service Parameters for an Object Group
Use this procedure to add ICMP service parameters to a service-type object group.
Procedure
Step 1 Choose Config > Virtual Contexts > context > Security > Object Groups.
The Object Groups table appears, listing existing object groups.
Step 2 Choose an existing service-type object group and then click the ICMP Service Parameters tab.
The ICMP Service Parameters table appears.
Step 3 Click Add to add an entry to this table.
Step 4 Configure ICMP type objects using the information in Table 4-22.
Table 4-22 ICMP Type Service Parameters
Field Description
ICMP Version Check either of the following check boxes for the ICMP version:
• ICMP—Internet Control Message Protocol (ICMP) for Internet Protocol
version 4 (IPv4).
• ICMPv6—Internet Control Message Protocol version 6 (ICMPv6) for
Internet Protocol version 6 (IPv6).
ICMP Type Select the ICMP type or number for this service object. Table 4-23 lists
common ICMP types and numbers. Table 4-24 lists the ICMPv6 types and
numbers.
Message Code Operator Select the operand to use when comparing message codes for this service
object:
• Equal To—The message code must be the same as the number in the
Message Code field.
• Greater Than—The message code must be greater than the number in the
Message Code field.
• Less Than—The message code must be less than the number in the
Message Code field.
• Not Equal To—The message code must not equal the number in the
Message Code field.
• Range—The message code must be within the range of codes specified
by the Min. Message Code field and the Max. Message Code field.
Message Code This field appears if you select Equal To, Greater Than, Less Than, or Not
Equal To in the Message Code Operator field.
Enter the ICMP message code for this service object.
Comments to this Manuals