12-12
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 12 Configuring Traffic Policies
Setting Match Conditions for Class Maps
Destination Address Indicates that a destination address is the match type for this match condition.
1. For the IP Address Type, select either IPv4 or IPv6 for the address type.
2. In the Destination Address field, enter the destination IP address for this match condition in
the format based on the address type (IPv4 or IPv6).
3. For an IPv4 destination address, in the Destination Netmask field, select the subnet mask of
the IP address.
For an IPv6 destination address, in the Destination Prefix-length field, enter the prefix length
for the address.
Port Indicates that a UDP or TCP port or range of ports is the match type for this match condition.
1. In the Port Protocol field, select TCP or UDP as the protocol to be matched.
2. In the Port Operator field, select the match criteria for the port:
–
Any—Indicates that any port using the selected protocol meets the match condition.
–
Equal To—Indicates that a specific port using the protocol meets the match condition.
In the Port Number field, enter the port to be matched. Valid entries are integers from 0 to
65535. A value of 0 indicates that the ACE appliance is to include all ports.
–
Range—Indicates that the port must be one of a range of ports to meet the match condition.
a. In the Lower Port Number field, enter the first port number in the port range for the
match condition.
b. In the Upper Port Number field, enter the last port number in the port range for the
match condition.
Valid entries are integers from 0 to 65535. A value of 0 indicates that the ACE appliance
is to include all ports.
Portv6 This option appears for Device Manager software Version A5(1.2) and later only. UDP or TCP port
or range of ports for IPv6 traffic that is the match type for this match condition.
For port configuration information, see Port.
Table 12-5 Layer 3/Layer 4 Network Traffic Class Map Match Condition Attributes (continued)
Match Condition Type Description
Comments to this Manuals