Cisco IPS 7.1 Installation Guide download pdf (Page 125)

100

101

4-25

Cisco Intrusion Prevention System Appliance Hardware Installation Guide for IPS 7.1

OL-24002-01

Chapter 4 Installing the IPS 4345 and IPS 4360

Removing and Installing the Power Supply

Figure 4-20 shows the DC power supply with lead wires.

Figure 4-20 DC Power Supply with Lead Wires

Step 7

Insert the exposed end of one of the ground wires into the inlet on the DC power supply. After you push

in the wires, they are held in place with a spring, which makes the physical contact. Make sure that you

cannot see any wire lead. Only wires with insulation should extend from the DC power supply.

Step 8 Repeat Step 5 through Step 7 for the remaining two DC input power source wires, the positive lead wire

and the negative lead wire.

Step 9 Use a tie wrap to secure the wires coming from the power supply to the rack so that the wires cannot be

pulled from the power supply by casual contact. Make sure the tie wrap allows for some slack in the

ground wire. Figure 4-21 shows the DC power supply with the wires inserted and the tie wrap secured.

Figure 4-21 Complete DC Secure Tie Wrap

Step 10

Remove the tape (if any) from the circuit breaker switch handle, and move the circuit breaker switch

handle to the On position. The power supply indicators light up when power is supplied to the appliance.

333060

1 Lead wires secured with a tie wrap

333061

1 ... 124 125 126 ... 422

Comments to this Manuals

No comments

Cisco IPS 7.1 Installation Guide Page 125

Comments to this Manuals

Related products and manuals for Networking Cisco IPS 7.1