Cisco IPS 7.1 Installation Guide download pdf (Page 179)

7-7

Cisco Intrusion Prevention System Appliance Hardware Installation Guide for IPS 7.1

OL-24002-01

Chapter 7 Installing and Removing the ASA 5585-X IPS SSP

Front Panel Features

Table 7-2 describes the front panel indicators on the ASA 5585-X IPS SSP.

Table 7-2 ASA 5585-X IPS SSP Front Panel Indicators

Indicator Description

PWR Indicates whether the system is off or on:

• Off—No power.

• Green—System has power.

BOOT Indicates how the power-up diagnostics are proceeding:

• Flashing green—Power-up diagnostics are running or the system is booting.

• Green—System has passed power-up diagnostics.

• Amber—Power-up diagnostics failed.

ALARM

1. The Cisco ASA software does not support the ALARM indicator initially; support will be added at a later date.

Indicates whether a component has failed:

• Off—No alarm.

• Flashing yellow—Critical alarm.

Major failure of hardware component or software module, temperature over

the limit, power out of tolerance, or OIR is ready to remove the module.

2. OIR is not available at this time.

ACT Indicates the status of an HA pair:

• Green—Status of an HA pair.

VPN Indicates whether a VPN tunnel has been established:

• Green—VPN tunnel is established.

PS1 Indicates the state of the power supply module installed on the right when facing

the back panel:

• Off—No power supply module present or no AC input.

• Green—Power supply module present, on, and good.

• Amber—Power or fan module off or failed.

PS0 Indicates the state of the power module installed on the left when facing the back

panel:

• Off—No power supply module present or no AC input.

• Green—Power supply module present, on, and good.

• Amber—Power or fan module off or failed.

HDD1 N/A

•

HDD2 N/A

•

1 ... 178 179 180 ... 422

No comments

Cisco IPS 7.1 Installation Guide Page 179