Cisco IPS 7.1 Installation Guide download pdf (Page 171)

6-7

Cisco Intrusion Prevention System Appliance Hardware Installation Guide for IPS 7.1

OL-24002-01

Chapter 6 Installing and Removing the ASA 5500 AIP SSM

Installation and Removal Instructions

• For the procedure for using HTTPS to log in to the IDM, refer to Logging In to the IDM.

Verifying the Status of the ASA 5500 AIP SSM

You can use the show module 1 command to verify that the ASA 5500 AIP SSM is up and running.

The following values are valid for the Status field:

• Initializing—The ASA 5500 AIP SSM is being detected and the control communication is being

initialized by the system.

• Up—The ASA 5500 AIP SSM has completed initialization by the system.

• Unresponsive—The system encountered an error communicating with the ASA 5500 AIP SSM.

• Reloading—The ASA 5500 AIP SSM is reloading.

• Shutting Down—The ASA 5500 AIP SSM is shutting down.

• Down—The ASA 5500 AIP SSM is shut down.

• Recover—The ASA 5500 AIP SSM is attempting to download a recovery image.

To verify the status of the ASA 5500 AIP SSM, follow these steps:

Step 1 Log in to the adaptive security appliance.

Step 2 Verify the status of ASA 5500 AIP SSM. If the status reads Up, the ASA 5500 AIP SSM has been

properly installed.

asa# show module 1

Mod Card Type Model Serial No.

--- -------------------------------------------- ------------------ -----------

1 ASA 5500 Series Security Services Module-20 ASA-SSM-20 P2B000005D0

Mod MAC Address Range Hw Version Fw Version Sw Version

--- --------------------------------- ------------ ------------ ---------------

1 000b.fcf8.0144 to 000b.fcf8.0144 0.2 1.0(9)0 5.0(0.27)S129.0

Mod Status

--- ------------------

1 Up

asa#

Removing the ASA 5500 AIP SSM

To remove the ASA 5500 AIP SSM from the adaptive security appliance, follow these steps:

Step 1 Shut down the ASA 5500 AIP SSM.

asa# hw-module module 1 shutdown

Shutdown module in slot 1? [confirm]

Step 2 Press Enter to confirm.

Step 3 Verify that the ASA 5500 AIP SSM is shut down by checking the indicators.

Step 4 Power off the adaptive security appliance.

1 ... 170 171 172 ... 422

No comments

Cisco IPS 7.1 Installation Guide Page 171