Cisco IPS 7.1 Installation Guide download pdf (Page 185)

100

101

7-13

Cisco Intrusion Prevention System Appliance Hardware Installation Guide for IPS 7.1

OL-24002-01

Chapter 7 Installing and Removing the ASA 5585-X IPS SSP

Removing and Replacing the ASA 5585-X IPS SSP

To verify the status of the ASA 5585-X IPS SSP, follow these steps:

Step 1 Log in to the adaptive security appliance.

Step 2 Verify the status of the ASA 5585-X IPS SSP:

asa# show module 1

Mod Card Type Model Serial No.

--- -------------------------------------------- ------------------ -----------

1 ASA 5585-X IPS Security Services Processor-2 ASA5585-SSP-IPS20 ABC1234D56E

Mod MAC Address Range Hw Version Fw Version Sw Version

--- --------------------------------- ------------ ------------ ---------------

1 0001.0001.0001 to 0001.0001.000c 1.0 2.0(7)0 7.1(3)E4

Mod SSM Application Name Status SSM Application Version

--- ------------------------------ ---------------- --------------------------

1 IPS Up 7.1(3)E4

Mod Status Data Plane Status Compatibility

--- ------------------ --------------------- -------------

1 Up Up

If the status reads Up, the ASA 5585-X IPS SSP has been properly installed.

Removing and Replacing the ASA 5585-X IPS SSP

To remove and replace the ASA 5585-X IPS SSP in the ASA 5585-X, follow these steps:

Step 1 Shut down the ASA 5585-X IPS SSP.

asa# hw-module module 1 shutdown

Shutdown module in slot 1? [confirm]

Step 2 Press Enter to confirm.

Step 3 Verify that the ASA 5585-X IPS SSP is shut down by checking the indicators.

Step 4 Power off the ASA 5585-X.

Step 5 Remove the power cable from the ASA 5585-X.

Step 6 From the front panel of the ASA 5585-X, loosen the captive screws on the upper left and right of the

ASA 5585-X IPS SSP in slot 1.

1 ... 184 185 186 ... 422

Comments to this Manuals

No comments

Cisco IPS 7.1 Installation Guide Page 185

Comments to this Manuals

Related products and manuals for Networking Cisco IPS 7.1