Cisco IPS 7.1 Installation Guide Page 326

  • Download
  • Add to my manuals
  • Print
  • Page
    / 422
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 325
E-56
Cisco Intrusion Prevention System Appliance Hardware Installation Guide for IPS 7.1
OL-24002-01
Appendix E Troubleshooting
Troubleshooting the IDM
d. Click the Cache tab.
e. Click Clear.
Step 3 If you have Java Plug-in 1.4.x installed:
a. Click Start > Settings > Control Panel > Java Plug-in 1.4.x.
b. Click the Advanced tab.
c. Under Java Runtime Environment, select JRE 1.3.x from the drop-down menu.
d. Click the Cache tab.
e. Click the Browser tab.
f. Deselect all browser check boxes.
g. Click Clear Cache.
Step 4 Delete the temp files and clear the history in the browser.
Cannot Launch the IDM-the Analysis Engine Busy
Error Message Error connecting to sensor. Failed to load
sensor-errNotAvailable-Analysis Engine is busy. Exiting IDM.
Possible Cause
This condition can occur if the Analysis Engine in the sensor is busy getting ready
to perform a task and so does not respond to the IDM.
Recommended Action Wait for a while and try again to connect.
The IDM, Remote Manager, or Sensing Interfaces Cannot Access the Sensor
If the IDM, a remote manager, or sensing interfaces cannot access the sensor, but you can access the
sensor CLI using SSH or Telnet (if enabled), follow these steps:
Step 1 Make sure the network configuration allows access to the web server port that is configured on the
sensor:
sensor# setup
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
User ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Current Configuration:
service host
network-settings
host-ip 192.168.1.2/24,192.168.1.1
host-name sensor
Page view 325
1 ... 325 326 327 ... 422

Comments to this Manuals

No comments