Cisco IPS 7.1 Installation Guide Page 64

  • Download
  • Add to my manuals
  • Print
  • Page
    / 422
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 63
3-16
Cisco Intrusion Prevention System Appliance Hardware Installation Guide for IPS 7.1
OL-24002-01
Chapter 3 Installing the IPS 4270-20
Accessories
Accessories
The IPS 4270-20 accessories kit contains the following:
DB-9 connector
DB-9/RJ-45 console cable
Two Ethernet RJ-45 cables
Regulatory Compliance and Safety Information for the Cisco Intrusion Detection and Prevention
System 4200 Series Appliance Sensor
Documentation Roadmap for Cisco Intrusion Prevention System
Installing the Rail System Kit
You can install the IPS 4270-20 in a 4-post rack. This section describes how to install the IPS 4270-20
in a rack, and contains the following sections:
Understanding the Rail System Kit, page 3-16
Rail System Kit Contents, page 3-17
Space and Airflow Requirements, page 3-17
Installing the IPS 4270-20 in the Rack, page 3-18
Extending the IPS 4270-20 from the Rack, page 3-26
Installing the Cable Management Arm, page 3-28
Converting the Cable Management Arm, page 3-32
Understanding the Rail System Kit
This rail system supports a variety of products that can be installed in round-, square, or threaded-hole
racks. The following illustration shows the three rack hole-types. Use Figure 3-11 to identify your rack
type and then follow the installation steps accordingly.
Figure 3-11 Round-, Square-, and Threaded-Hole Racks
250205
Round-hole racks Square-hole racks Threaded-hole racks
No tools required No tools required Tools required:
standard screwdriver,
Phillips screwdriver,
or T-25 Torx driver
Page view 63
1 ... 63 64 65 ... 422

Comments to this Manuals

No comments