Cisco IPS 7.1 Installation Guide Page 162

  • Download
  • Add to my manuals
  • Print
  • Page
    / 422
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 161
5-34
Cisco Intrusion Prevention System Appliance Hardware Installation Guide for IPS 7.1
OL-24002-01
Chapter 5 Installing the IPS 4510 and IPS 4520
Troubleshooting Loose Connections
Figure 5-18 Cable Management Brackets for the Slide Rail
Step 4 Tighten the screws in to the rack.
Step 5 Reattach the power cable to the sensor.
Step 6 Organize the cables through the cable management brackets on the sensor.
Step 7 Power on the sensor.
Troubleshooting Loose Connections
Perform the following actions to troubleshoot loose connections on sensors:
Make sure all power cords are securely connected.
Make sure all cables are properly aligned and securely connected for all external and internal
components.
Remove and check all data and power cables for damage. Make sure no cables have bent pins or
damaged connectors.
Make sure each device is properly seated.
If a device has latches, make sure they are completely closed and locked.
Check any interlock or interconnect indicators that indicate a component is not connected properly.
If problems continue, remove and reinstall each device, checking the connectors and sockets for bent
pins or other damage.
333053
Page view 161
1 ... 161 162 163 ... 422

Comments to this Manuals

No comments