Cisco IPS 7.1 Installation Guide download pdf (Page 262)

100

101

D-22

Cisco Intrusion Prevention System Appliance Hardware Installation Guide for IPS 7.1

OL-24002-01

Appendix D Upgrading, Downgrading, and Installing System Images

Installing System Images

Step 5 If necessary, assign an IP address for the local port on the IPS 4510.

rommon> ADDRESS=ip_address

Note Use the same IP address that is assigned to the IPS 4510.

Step 6 If necessary, assign the TFTP server IP address.

rommon> SERVER=ip_address

Step 7 If necessary, assign the gateway IP address.

rommon> GATEWAY=ip_address

Step 8 Verify that you have access to the TFTP server by pinging it from your local Ethernet port with one of

the following commands:

rommon> ping server_ip_address

rommon> ping server

Step 9 If necessary define the path and filename on the TFTP file server from which you are downloading the

image.

rommon> IMAGE=path/file_name

UNIX Example

rommon> IMAGE=/system_images/IPS-4510-K9-sys-1.1-a-7.1-4-E4.img

Note The path is relative to the UNIX TFTP server default tftpboot directory. Images located in the

default tftpboot directory do not have any directory names or slashes in the IMAGE

specification.

Windows Example

rommon> IMAGE=\system_images\IPS-4510-K9-sys-1.1-a-7.1-4-E4.img

Step 10 Enter set and press Enter to verify the network settings.

Note You can use the sync command to store these settings in NVRAM so they are maintained across

boots. Otherwise, you must enter this information each time you want to boot an image from

ROMMON.

Step 11 Download and install the system image.

rommon> tftp

Caution To avoid corrupting the system image, do not remove power from the IPS 4510 while the system image

is being installed.

1 ... 261 262 263 ... 422

Comments to this Manuals

No comments

Cisco IPS 7.1 Installation Guide Page 262

Comments to this Manuals

Related products and manuals for Networking Cisco IPS 7.1