4-27
Cisco Intrusion Prevention System Appliance Hardware Installation Guide for IPS 7.1
OL-24002-01
Chapter 4 Installing the IPS 4345 and IPS 4360
Removing and Installing the Power Supply
c. Push the lever on the power supply to the left and remove the power supply by grasping the handle
and then pulling the power supply out of the chassis while supporting it from beneath with the other
hand (Figure 4-24).
Figure 4-24 Removing the DC Power Supply
Step 7 Install the new power supply by lining it up with the power supply bay and pushing it into place until it
is seated while supporting it from beneath with the other hand (Figure 4-25).
Figure 4-25 Installing the DC Power Supply
Step 8
To connect the DC input power source wires, see Step 5 though Step 10 in Installing DC Input Power,
page 4-21.
Comments to this Manuals