5-22
Cisco Intrusion Prevention System Appliance Hardware Installation Guide for IPS 7.1
OL-24002-01
Chapter 5 Installing the IPS 4510 and IPS 4520
Installing and Removing the Slide Rail Kit
Package Contents
The slide rail kit package contains the following items:
• Left and right slide rails
• Six #10-32 screws
• Two #10-32 cage nuts
Installing the Chassis in the Rack
To install the chassis in the rack using the slide rail kit, follow these steps:
Step 1 Press the latch on the end of the slide rail and push forward to engage the pins in the rack until the clip
clicks and locks around the rack post (Figure 5-8).
Note The slide rails are labeled ‘left’ and ‘right.’ Install the left slide rail on the left side of the rack
and the right slide rail on the right side of the rack.
Figure 5-8 Press and Push to Install the Slide Rail
Comments to this Manuals