5-33
Cisco Intrusion Prevention System Appliance Hardware Installation Guide for IPS 7.1
OL-24002-01
Chapter 5 Installing the IPS 4510 and IPS 4520
Installing the Cable Management Brackets
Installing the Cable Management Brackets
The IPS 4510 and IPS 4520 ship with two cable management brackets that you can use to organize the
cables connected to the sensor.
To install the cable management brackets on the sensor, follow these steps:
Step 1 Power off the sensor.
Step 2 Remove the power cable from the sensor.
Step 3 Position the cable management brackets on the front side of the sensor, and line up the bracket screws
with the screw holes on the sensor. Figure 5-17 shows the cable management bracket for the fixed rack
mount and Figure 5-18 on page 5-34 shows the cable management bracket for the slide rail.
Figure 5-17 Cable Management Brackets for the Fixed Rack Mount
331824
PWR
BOOT
ALARM
ACT
VPN
PS1
HDD1
PS0
HDD0
USB
RESET
0
SFP3
SFP2
SFP1
SFP0
1
0
1
2345
MGMT
0
1
AUX CONSOLE
PWR
BOOT
ALARM
ACT
VPN
PS1
HDD1
PS0
HDD0
USB
RESET
0
SFP3
SFP2
SFP1
SFP0
10
1
2
3
45
MGMT
0
1
AUX
CONSOLE
Cisco IPS 4510
Comments to this Manuals