2-122
Cisco SCE 8000 CLI Command Reference
Chapter 2 CLI Command Reference
diameter Gx virtual-gi multi-mapping
diameter Gx virtual-gi multi-mapping
Configures multiple VLAN ID to a virtual Gi ID mapping.
diameter Gx virtual-gi multi-mapping {enable| disable| disable force}
Syntax Description
Command Default None
Command Modes Global configuration
Command History This table includes the following release-specific history entries:
Usage Guidelines Authorization: admin
When configuring a VLAN ID mapping to an already mapped virtual Gi ID, by default, the previous
VLAN ID is overwritten because only one VLAN ID can be mapped to a virtual Gi ID.
Examples The following example shows how to enable TACACS+ accounting for the admin privilege level (10):
Enable and configure multi-mapping:
SCE8000#>
SCE8000#> configure
SCE8000(config)#> diameter gx virtual-gi multi-mapping enable
SCE8000(config)#> end
SCE8000#> show diameter gx virtual-gi multi-mapping
Multiple VLAN ID to single VGi ID mapping supported
SCE8000#>
SCE8000#> configure
SCE8000(config)#> diameter gx virtual-gi vlan-id 1 mapping 100
SCE8000(config)#> diameter gx virtual-gi vlan-id 2 mapping 100
SCE8000(config)#> diameter gx virtual-gi vlan-id 3 mapping 100
SCE8000#>
enable Enables multiple VLAN ID to a virtual Gi ID mapping. Cisco SCE adds the
new VLAN ID mapping to an existing VGi ID without overwriting the
VLAN ID.
disable Disables multiple VLAN ID to a virtual Gi ID mapping if no two or more
VLAN IDs are configured to a VGi ID.
disable force Disables multi-mapping configurations on the device and removes all
multi-mapping configurations.
Release Modification
4.1.0 This command was introduced.
Comments to this Manuals