2-357
Cisco SCE 8000 CLI Command Reference
Chapter 2 CLI Command Reference
scmp name
scmp name
Adds an SCMP peer device.
To delete the specified SCMP peer device, use the no form of this command.
scmp name name radius hostname secret secret [auth-port [auth-port]] [acct-port [acct-port] ]
no scmp name name
Syntax Description
Command Default The default port configuration is as specified in RFC 2865 and RFC 2866.
The default authentication port is 1812.
The default accounting port is 1813.
Command Modes Global configuration
Command History This table includes the following release-specific history entries:
Usage Guidelines After defining an SCMP peer device, you must associate it with one or more unmapped anonymous
groups (see subscriber anonymous-group name scmp name). This association provides the ability to
query the SCMP peer regarding unmapped IP addresses if the Cisco SCE platform is not updated when
the subscriber session has started (see scmp subscriber send-session-start) or in recovery scenarios.
You cannot delete an SCMP device that has anonymous groups assigned to it. Use the no subscriber
anonymous-group name scmp name command to remove all associated anonymous groups before
deleting the device.
Authorization: admin
Examples The following example shows how to define an SCMP peer device:
SCE8000>enable 10
Password:<cisco>
SCE8000#config
SCE8000(config)# scmp name peer_device1 radius radius1 secret abcdef
SCE8000(config)#
name Name of the SCMP peer device.
hostname IP address or name of the RADIUS host.
secret RADIUS shared secret.
auth-port Authentication port number.
acct-port Accounting port number.
Release Modification
3.0.3 This command was introduced.
Comments to this Manuals