2-176
Cisco SCE 8000 CLI Command Reference
Chapter 2 CLI Command Reference
interface gigabitethernet
Usage Guidelines The format of this command depends on the version of the Cisco SCE 8000 platform and the type of
interface being configured, as described Table 2-4.
To return to Global configuration mode, use the exit command.
The system prompt changes to reflect GigabitEthernet Interface Configuration mode.
Authorization: admin
Examples The following example shows how to enter GigabitEthernet Interface Configuration mode to configure
the management port (SCE 8000 GBE and SCE 8000 10GBE):
SCE8000>enable 10
Password:<cisco>
SCE8000#config
SCE8000(config)#interface gigabitethernet 1/1
SCE8000(config if)#
The following example shows how to enter GigabitEthernet Interface Configuration mode to configure
a GBE line port in subslot 1 of platform 0 in a cascaded pair (SCE 8000 GBE only):
SCE8000>enable 10
Password:<cisco>
SCE8000#config
SCE8000(config)#interface gigabitethernet 0/3/1/5
SCE8000(config if)#
Table 2-4 Interface gigabitethernet Command Formats
Authorization Level or
Command Mode Use this command to access
Use this command to
exit
SCE 8000 10GBE Management interface
gigabitethernet 1/1
SCE 8000 GBE Management interface
gigabitethernet 1/1
SCE 8000 GBE GBE line interface
gigabitethernet
3/0/(0-7)
interface
gigabitethernet
3/1/(0-7)
Cascaded SCE 8000 GBE GBE line interface
gigabitethernet 0/
3/(0-1)/(0-7)
interface
gigabitethernet 1/
3/(0-1)/(0-7)
Comments to this Manuals