2-167
Cisco SCE 8000 CLI Command Reference
Chapter 2 CLI Command Reference
force failure-condition
force failure-condition
Forces a virtual failure condition, and exits from the failure condition, when performing an application
upgrade.
To disable forcing a virtual failure condition, use the no form of this command.
force failure-condition
no force failure-condition
Syntax Description This command has no arguments or keywords.
Command Default None
Command Modes Interface Linecard Configuration
Command History This table includes the following release-specific history entries:
Usage Guidelines When upgrading the application in a cascaded system, use this command to force failure in the active
SCE 8000 platform (see System Upgrades in the Cisco SCE8000 10GBE Software Configuration Guide
or System Upgrades in the Cisco SCE8000 GBE Software Configuration Guide).
Authorization: admin
Examples The following example shows how to force a virtual failure condition.
At the displayed “n,” type Y and press Enter to confirm the forced failure.
SCE8000>enable 10
Password:<cisco>
SCE8000#config
SCE8000(config)#interface linecard 0
SCE8000(config if)#force failure-condition
Forcing failure will cause a failover - do you want to continue? n
SCE8000(config if)#
Related Commands
Release Modification
2.5.7 This command was introduced.
Command Description
pqi upgrade file Upgrades the application using the specified pqi file and any specified
upgrade options.
Comments to this Manuals