Cisco SCE8000 Specifications download pdf (Page 131)

100

101

2-91

Cisco SCE 8000 CLI Command Reference

Chapter 2 CLI Command Reference

connection-mode

Usage Guidelines

Caution This command can be used only if the line card is in either no-application or shutdown mode.

Note The sce-id argument, which identifies the Cisco SCE platform, replaces the physically-connected-link

argument, which identified the link. This change was required with the introduction of the Cisco SCE

8000 GBE platform, which supports multiple links. However, for backward compatibility, the

physically-connected-link argument is still recognized and the number of the link assigned to that

argument (0 or 1) is defined as the Cisco SCE ID.

Authorization: admin

Examples The following example shows how to configure the primary SCE 8000 platform in a two-SCE platform

inline topology. This device is designated as SCE platform 0, and the behavior of the Cisco SCE platform

if a failure occurs is bypass (default).

SCE8000>enable 10

Password: <cisco>

SCE8000#config

SCE8000(config)#interface linecard 0

SCE8000(config if)#connection-mode inline-cascade sce-id 0 priority primary on-failure

bypass

SCE8000(config if)#

Related Commands Command Description

show interface linecard connection-mode Displays the current configuration of the

Cisco SCE platform traffic-link connection.

show interface linecard physically-connected- links Displays the link mapping for the line card

interface.

show interface linecard cascade connection-status Displays information about the connection

between two cascaded SCE 8000 platforms,

using the cascade interfaces.

show interface linecard cascade peer-sce-information Displays information about the peer SCE

platform.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 777 778

Comments to this Manuals

No comments

Cisco SCE8000 Specifications Page 131

Comments to this Manuals