2-235
Cisco SCE 8000 CLI Command Reference
Chapter 2 CLI Command Reference
line vty
line vty
Enters Line Configuration mode for Telnet lines, which configures all Telnet lines.
line vty start-number [end-number]
Syntax Description
Command Default None
Command Modes Global configuration
Command History This table includes the following release-specific history entries:
Usage Guidelines The system prompt changes to reflect Line Configuration mode. To return to Global configuration mode,
use the exit command.
Authorization: admin
Examples The following example shows how to enter Line Configuration mode for all lines:
SCE8000>enable 10
Password:<cisco>
SCE8000#config
SCE8000(config)#line vty 0
SCE8000(config-line)#
Related Commands
start-number Starting number ranging from 0 to 4. The actual number supplied does not
matter. All Telnet lines are configured by this command.
end-number Ending number ranging from 0 to 4. The actual number supplied does not
matter. All Telnet lines are configured by this command.
Release Modification
2.5.7 This command was introduced.
Command Description
show line vty Displays the Telnet configuration.
exit Exits from the current mode to the next “lower” level.
Comments to this Manuals