Cisco SCE8000 Specifications download pdf (Page 468)

100

101

2-428

Cisco SCE 8000 CLI Command Reference

Chapter 2 CLI Command Reference

show interface linecard attack-detector

Displays the configuration of the specified attack detector.

show interface linecard slot-number attack-detector [default | all]

show interface linecard slot-number attack-detector attack-detector

Syntax Description

Command Default None

Command Modes User EXEC

Command History This table includes the following release-specific history entries:

Usage Guidelines When you specify the all or default keyword, the following information is displayed:

• Protocol side—Whether the attack detector applies to attacks originating at the subscriber or

network side.

• Direction—Whether the attack detector applies to single-sided or dual-sided attacks.

• Action to take if an attack is detected.

• Thresholds:

–

open-flows-rate—Default threshold for the rate of open flows (new open flows per second).

–

suspected-flows-rate—Default threshold for the rate of suspected DDoS flows (new suspected

flows per second).

–

suspected-flows-ratio—Default threshold for the ratio of suspected flow rate to open flow rate.

• Subscriber notification—Enabled or disabled.

• Alarm—Sending an SNMP trap is enabled or disabled.

Authorization: viewer

slot-number Number of the identified slot. Enter a value of 0.

default Displays the default attack detector configuration.

all Displays the configuration of all existing attack detectors.

attack-detector Number of the specific attack detector to be displayed.

Release Modification

2.5.7 This command was introduced.

1 2 ... 463 464 465 466 467 468 469 470 471 472 473 ... 777 778

Comments to this Manuals

No comments

Cisco SCE8000 Specifications Page 468

Comments to this Manuals