Cisco ONS 15454 SDH Specifications download pdf (Page 120)

2-36

Cisco ONS 15454 SDH Installation and Operations Guide, R3.3

May 2002

Chapter 2 Set up PC and Log into CTC

Using the Node View

2.9.2 Node View Card Shortcuts

If you move your mouse over FMECs in the upper shelf of the graphic, tooltips displays the equipment

FMEC card type. If you move your mouse over cards in the lower shelf in the graphic, tooltips displays

additional information about the card including the card type, card status (active or standby), the number

of critical, major, and minor alarms (if any), and the alarm profile used by the card. Right-clicking a card

reveals a shortcut menu, which you can use to open, reset, or delete a card. Right-click a slot (grey) to

pre-provision a card in the lower shelf (i.e., provision a slot before installing the card in the lower shelf).

Note The FMECs in the upper shelf cannot be pre-provisioned.

Note CTC software does not monitor for the presence or absence of FMECs unless the TCC-I(s) card has

reached the active/standby state. During transitional states such as power-up or TCC-I reset CTC

ignores the FMEC inventory displayed in node view.

Procedure: Add a Node to the Current Session

Step 1 From the CTC File menu, click Add Node (or click the Add Node button on the toolbar).

Step 2 On the Add Node dialog box, enter the node name (or IP address).

Step 3 If you want to add the node to the current login group, click Add Node to Current Login Group.

Otherwise, leave it unchecked.

Step 4 Click OK.

After a few seconds, the new node will be displayed on the network view map.

2.9.3 Check Inventory from the Node View

The Inventory tab (Figure 2-10) displays information about cards installed in the ONS 15454 SDH node

including location, equipment type, hardware part numbers, hardware revisions, and serial numbers. The

Inventory tab provides information about ONS 15454 SDH Product Change Notices (PCNs) and Field

Service Bulletins (FSBs). Using the ONS 15454 SDH export feature, you can export inventory data from

ONS 15454 SDH nodes into spreadsheet and database programs to consolidate ONS 15454 SDH

information for network inventory management and reporting.

Purpose During a CTC session, you can add nodes that are not displayed in the

session without having to log out of the session. When you add the node,

you have the option to add it to the current login node group.

Prerequisite Procedures “Logging into CTC” procedure on page 2-22

Onsite/Remote Onsite or remote

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 503 504

No comments

Cisco ONS 15454 SDH Specifications Page 120