Cisco ONS 15454 SDH Specifications download pdf (Page 370)

9-24

Cisco ONS 15454 SDH Installation and Operations Guide, R3.3

May 2002

Chapter 9 Ethernet Operation

E Series Circuit Configurations

The Circuit Creation (Circuit VLAN Selection) dialog box opens (Figure 9-12 on page 9-16).

Step 16 Create the VLAN:

a. Click the New VLAN tab.

The Circuit Creation (Define New VLAN) dialog box opens (Figure 9-15 on page 9-20).

b. Assign an easily-identifiable name to your VLAN.

c. Assign a VLAN ID.

This should be the next available number (between 2 and 4093) not already assigned to an existing

VLAN. Each ONS 15454 SDH network supports a maximum of 509 user-provisionable VLANs.

d. Click OK.

e. Highlight the VLAN name and click the >> tab to move the VLAN(s) from the Available VLANs

column to the Circuit VLANs column (Figure 9-16 on page 9-20).

Step 17 Click Next.

The Circuit Creation (Circuit Routing Preferences) dialog box opens.

Step 18 Confirm that the following information about the point-to-point circuit is correct:

• Circuit name

• Circuit type

• Circuit size

• VLANs that will be transported across this circuit

• ONS 15454 SDH nodes included in this circuit

Note If the circuit information is not correct, click the Back button and repeat the procedure with the

correct information. You can also click Finish, highlight the completed circuit, click the Delete

button and start the procedure from the beginning.

Step 19 Click Finish.

You must now provision the second circuit and attach it to the already-created VLAN.

Step 20 Log into the ONS 15454 SDH Ethernet circuit endpoint for the second circuit.

Step 21 Double-click the Ethernet card that will create the circuit. The CTC card view displays.

Step 22 Click the Provisioning > Card tabs.

Step 23 Under Card Mode, check Single-card EtherSwitch.

If the Single-card EtherSwitch checkbox is not checked, check it and click Apply.

Step 24 Log into the other ONS 15454 SDH endpoint for the second circuit and repeat Steps 21 – 23.

Step 25 Display the CTC node view.

Step 26 Click the Circuits tab and click Create.

Step 27 Choose VC_HO_PATH_CIRCUIT from the Type pull-down menu.

Step 28 Choose the size of the circuit from the Size pull-down menu.

Step 29 Verify that the Bidirectional checkbox is checked and click Next.

Step 30 Choose the circuit source from the Node menu and click Next.

Either end node can be the circuit source.

1 2 ... 365 366 367 368 369 370 371 372 373 374 375 ... 503 504

No comments

Cisco ONS 15454 SDH Specifications Page 370