Cisco ONS 15454 SDH Specifications download pdf (Page 343)

8-39

Cisco ONS 15454 SDH Installation and Operations Guide, R3.3

May 2002

Chapter 8 SDH Performance Monitoring

SDH Performance Monitoring for Optical Cards

MS-PPJC-Pgen

Multiplex Section Positive Pointer Justification Count, Path Generated

(MS-PPJC-Pgen) is a count of the positive pointer justifications generated

for a particular path.

MS-NPJC-Pgen

Multiplex Section Negative Pointer Justification Count, Path Generated

(MS-PPJC-Pgen) is a count of the negative pointer justifications

generated for a particular path.

Table 8-31 Protection Switch Count PMs for the STM-16 and STM-64 Cards, Near-End

Parameter Definition

For information about Troubleshooting SNCP switch counts, see the alarm troubleshooting

information in the Cisco ONS 15454 SDH Troubleshooting and Reference Guide. For information

about creating circuits that perform a switch, see Chapter 6, “Circuits and Tunnels.”

MS-PSC (MS-SPRing)

For a protect line in a 2-fiber ring, Multiplex Section Protection Switching

Count (MS-PSC) refers to the number of times a protection switch has

occurred either to a particular span’s line protection or away from a

particular span’s line protection. Therefore, if a protection switch occurs

on a 2-fiber MS-SPRing, the MS-PSC of the protection span to which the

traffic is switched will increment, and when the switched traffic returns to

its original working span from the protect span, the MS-PSC of the protect

span will increment again.

MS-PSC (1+1 protection)

In a 1 + 1 protection scheme for a working card, Multiplex Section

Protection Switching Count (MS-PSC) is a count of the number of times

service switches from a working card to a protection card plus the number

of times service switches back to the working card.

For a protection card, MS-PSC is a count of the number of times service

switches to a working card from a protection card plus the number of

times service switches back to the protection card. The MS-PSC PM is

only applicable if revertive line-level protection switching is used.

MS-PSD

For an active protection line in a 2-fiber MS-SPRing, Multiplex Section

Protection Switching Duration (MS-PSD) is a count of the number of

seconds that the protect line is carrying working traffic following the

failure of the working line. MS-PSD increments on the active protect line

and MS-PSD-W increments on the failed working line.

MS-PSC-W

For a working line in a 2-fiber MS-SPRing, Multiplex Section Protection

Switching Count-Working (MS-PSC-W) is a count of the number of times

traffic switches away from the working capacity in the failed line and

back to the working capacity after the failure is cleared. MS-PSC-W

increments on the failed working line and MS-PSC increments on the

active protect line.

For a working line in a 4-fiber MS-SPRing, MS-PSC-W is a count of the

number of times service switches from a working line to a protection line

plus the number of times it switches back to the working line. MS-PSC-W

increments on the failed line and MS-PSC-R or MS-PSC-S increments on

the active protect line.

Table 8-30 Pointer Justification Count PMs for the STM-16 and STM-64 Cards, Near-End (continued)

Parameter Definition

1 2 ... 338 339 340 341 342 343 344 345 346 347 348 ... 503 504

Comments to this Manuals

No comments

Cisco ONS 15454 SDH Specifications Page 343

Comments to this Manuals

Related products and manuals for Security access control systems Cisco ONS 15454 SDH