6-36
Cisco Unified Communications Manager Managed Services Guide, Release 8.0(1)
OL-20105-01
Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages
Preconfigured CallManager Alarm Notifications
DBChangeNotifyFailure
This alert occurs when the Cisco Database Notification Service experiences problems and might stop.
This condition indicates change notification requests that are queued in the database got stuck and
changes made to the system will not take effect. Ensure that the Cisco Database Layer Monitor is running
on the node where the alert exists. If it is, restart the service. If that does not return this alert to safe range,
collect the output of show tech notify and show tech dbstateinfo and contact TAC for information
about how to proceed.
DBReplicationFailure
This alarm indicates a failure in IDS replication and requires database administrator intervention.
Note Be aware that DBReplicationFailure is based on the replication status perfmon counter (instead
of DBReplicationFailure alarm as was previously the case). This alert gets triggered whenever
the corresponding replication status perfmon counter specifies a value of 3 (Bad Replication) or
4 (Replication Setup Not Successful).
Enable E-mail Selected
Trigger Alert Action Default
Table 6-29 Default Configuration for the CodeYellow RTMT Alert (continued)
Value Default Configuration
Ta b l e 6-30 Default Configuration for the DBChangeNotifyFailure RTMT Alert
Value Default Configuration
Enable Alert Selected
Severity Critical
Enable/Disable this
alert on the
following servers
Enabled on listed servers
Threshold Trigger alert when following condition met:
DBChangeNotify queue delay over 2 minutes
Duration Trigger alert immediately
Frequency Trigger up to 1 alert within 30 minutes
Schedule 24 hours daily
Enable E-mail Selected
Trigger Alert Action Default
Comments to this Manuals