6-93
Cisco Unified Communications Manager Managed Services Guide, Release 8.0(1)
OL-20105-01
Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages
Error-Level Alarms
Recommended Action
Notify the service provider responsible for sending the Setup message that an IE with Coding Standard
values of 0 or 1 must be included in Setup messages.
ConnectionFailureToPDP
A connection request from Unified CM to the policy decision point (PDP) failed. The failure may have
been a result of the following conditions:
• Network error causing limited or no connectivity between Unified CM and the PDP
• Authentication errors when Unified CM established an HTTPS connection to the PDP
• PDP was not in service.
Cisco Unified Serviceability Alarm Definition Catalog
CallManager/CallManager
Severity
Error(3)
Routing List
SDL
SDI
Sys Log
Event Log
Data Collector
Parameters
Policy Decision Point(String)
The cause of the connection failure(String)
Recommended Action
Verify the network connectivity between Unified CM and the PDP by pinging the policy server host
from Cisco Unified OS Administration and take steps to establish connectivity if it has been lost. If the
connection failure is due to an authentication problem, verify that the valid certificate of the PDP has
been imported to Cisco Unified OS Administration and certificates from every node in the Unified CM
cluster have been imported to every node in the PDP. Also, check whether the PDP service is active.
CtiProviderOpenFailure
CTI application is unable to open the provider. The IP address is shown in either IPv4 or IPv6 format
depending on the IP addressing mode of the application.
Comments to this Manuals