Cisco 2650 - 2650 Router Specifications download pdf (Page 180)

5-80

Cisco IOS Telephony Service, Version 2.02

Chapter 5 Command Reference

max-ephones (telephony-service)

To configure the maximum number of Cisco IP phones that can be supported by the router, use the

max-ephones command in telephony-service configuration mode. To return to the default number of

Cisco IP phones, use the no form of this command.

max-ephones max phones

no max-ephones

Syntax Description

Defaults The default is 0.

Command Modes Telephony-service configuration

Command History

Usage Guidelines The max-ephones command limits the number of Cisco IP phones (ephones) available. The maximum

number supported by a router is platform- and version-dependent. Use CLI help to determine the

maximum number of ephones you can set using this command, as shown in this example:

Router(config-telephony-service)# max-ephones ?

<1-48> Maximum phones to support

Note You can increase the number of phones; but after the maximum allowable number is configured, you

cannot reduce the limit of the Cisco IP phones without rebooting the router.

max phones Maximum number of phones supported by the router. The maximum

number is version- and platform-dependent; for a range of values, refer to

Cisco IOS command-line interface (CLI) help. Default is 0.

Release Modification

12.1(5)YD This command was introduced on the following platforms:

Cisco 2600 series and Cisco 3600 series multiservice routers, and

Cisco IAD2420 series IADs.

12.2(2)XT This command was implemented on the Cisco 1750 and

Cisco 1751 multiservice routers.

12.2(8)T This command was integrated into Cisco IOS Release 12.2(8)T and

implemented on the Cisco 3725 and Cisco 3745 routers.

12.2(8)T1 This command was implemented on the Cisco 2600-XM and Cisco 2691

routers.

12.2(11)T This command was integrated into Cisco IOS Release 12.2(11)T and

implemented on the Cisco 1760 routers.

1 ... 179 180 181 ... 266

No comments

Cisco 2650 - 2650 Router Specifications Page 180