Cisco 2650 - 2650 Router Specifications Page 195

  • Download
  • Add to my manuals
  • Print
  • Page
    / 266
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 194
5-95
Cisco IOS Telephony Service, Version 2.02
Chapter 5 Command Reference
number (ephone-dn)
number (ephone-dn)
To configure a valid number for the Cisco IP phone, use the number command in ephone-dn
configuration mode. To disable a number for the Cisco IP phone, use the no form of this command.
number number [secondary number] [no-reg [both | primary]]
no number number [secondary number] [no-reg [both | primary]]
Syntax Description
Defaults No secondary phone number is associated with the ephone-dn.
Command Modes Ephone-dn configuration
Command History
Usage Guidelines The number command configures a valid number for the Cisco IP phone. The secondary keyword
allows you to associate a second telephone number with an ephone-dn so that the Cisco IP phone line
can be called by dialing either the main or secondary phone number. The secondary number may contain
wildcards; for example, 50.. (number 50 followed by wildcards). The no-reg keyword specifies an E.164
number in the dial peer to not register to the gatekeeper. If you do not specify either both or primary
after the no-reg keyword, then only the secondary number is not registered.
number E.164 telephone number.
secondary (Optional) A second telephone number with an ephone-dn.
no-reg (Optional) The E.164 numbers in the dial peer do not register to the
gatekeeper. If you do not specify any option (both or primary) after the
no-reg keyword, then only the secondary number is not registered.
both (Optional) Both numbers are not registered.
primary (Optional) Primary number is not registered.
Release Modification
12.1(5)YD This command was introduced on the following platforms:
Cisco 2600 series and Cisco 3600 series multiservice routers, and
Cisco IAD2420 series IADs.
12.2(2)XT This command was implemented on the Cisco 1750 and
Cisco 1751 multiservice routers.
12.2(8)T This command was integrated into Cisco IOS Release 12.2(8)T and
implemented on the Cisco 3725 and Cisco 3745 routers.
12.2(8)T1 This command was implemented on the Cisco 2600-XM and Cisco 2691
routers.
12.2(11)T This command was integrated into Cisco IOS Release 12.2(11)T and
implemented on the Cisco 1760 routers.
Page view 194
1 ... 194 195 196 ... 266

Comments to this Manuals

No comments