Cisco 2650 - 2650 Router Specifications Page 35

  • Download
  • Add to my manuals
  • Print
  • Page
    / 266
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 34
2-15
Cisco IOS Telephony Service, Version 2.02
Chapter 2 Required Configuration Tasks
Verification and Troubleshooting
Configuring Reset for Specific Cisco IP Phones
This process resets a specific Cisco IP phone after the required configuration is complete.
SUMMARY STEPS
1. ephone tag
2. reset
DETAILED STEPS
Verification and Troubleshooting
Verifying Cisco IOS Telephony Service Configuration, page 2-15
Troubleshooting the Cisco IOS Telephony Service Router, page 2-16
Verifying Cisco IOS Telephony Service Configuration
To verify that the Cisco IOS Telephony Service is enabled, perform the following steps:
Step 1 Enter the show run command to verify the configuration.
Step 2 Enter the show telephony-service all command to verify that Cisco IOS Telephony Service router is
enabled.
Step 3 Verify that DHCP is configured.
Step 4 Verify that TFTP is configured.
Step 5 Enter the dir command to verify that the SEPDEFAULT.cnf file, XMLDefault.cnf.xml file, and the
phone firmware files are stored in the router’s Flash memory.
Step 6 Enter the show ephone [mac-address] command to verify all Cisco IP phones in the network.
Command Purpose
Step 1
Router(config)# ephone tag
Enters ephone configuration mode to register Cisco IP phones.
Step 2
Router(config-ephone)# reset
Resets a specific Cisco IP phone in ephone configuration mode.
Page view 34
1 ... 34 35 36 ... 266

Comments to this Manuals

No comments