Cisco 2650 - 2650 Router Specifications download pdf (Page 250)

5-150

Cisco IOS Telephony Service, Version 2.02

Chapter 5 Command Reference

timeouts interdigit (telephony-service)

To configure the interdigit timeout value for all Cisco IP phones attached to the router, use the timeouts

interdigit command in telephony-service configuration mode. To disable the interdigit timeout value,

use the no form of this command.

timeouts interdigit seconds

no timeouts interdigit seconds

Syntax Description

Defaults The default is 10 seconds.

Command Modes Telephony-service configuration

Command History

Usage Guidelines The timeouts interdigit command specifies the number of seconds the system waits after a caller enters

the initial digit or a subsequent digit of the dialed string. The timeouts interdigit timer is activated when

the caller enters a digit and is restarted each time the caller enters subsequent digits until the destination

address is identified. If the configured timeout value is exceeded before the destination address is

identified, a tone sounds and the call is terminated. The default is 10 seconds.

To disable the timeouts interdigit timer, set the seconds value to zero.

Examples The following example shows the interdigit timeout value set to 5 seconds for all Cisco IP phones:

Router(config)# telephony-service

Router(config-telephony-service)# timeouts interdigit 5

seconds Interdigit timeout duration, in seconds, set on the timer for all the

Cisco IP phones. Valid entries are from 2 to 120 seconds.

Release Modification

12.2(2)XB This command was introduced on the following platforms:

Cisco 2600 series and Cisco 3600 series multiservice routers, and

Cisco IAD2420 series IADs.

12.2(2)XT This command was implemented on the Cisco 1750 and

Cisco 1751 multiservice routers.

12.2(8)T This command was integrated into Cisco IOS Release 12.2(8)T and

implemented on the Cisco 3725 and Cisco 3745 routers.

12.2(8)T1 This command was implemented on the Cisco 2600-XM and Cisco 2691

routers.

12.2(11)T This command was integrated into Cisco IOS Release 12.2(11)T and

implemented on the Cisco 1760 routers.

1 ... 249 250 251 ... 266

No comments

Cisco 2650 - 2650 Router Specifications Page 250