Cisco MWR 2941 Installation Manual Page 109

  • Download
  • Add to my manuals
  • Print
  • Page
    / 710
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 108
-109
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR
ethernet cfm domain level
ethernet cfm domain level
To define a connectivity fault management (CFM) maintenance domain at a particular maintenance level
and put the command-line interface (CLI) into Ethernet CFM configuration mode, use the ethernet cfm
domain level command in global configuration mode. To remove the CFM domain at the specified level,
use the no form of this command.
Note This command has been replaced with the ethernet cfm global command in Cisco IOS Release
15.0(1)MR.
ethernet cfm domain domain-name level level-id
no ethernet cfm domain domain-name level level-id
Syntax Description
Command Default No maintenance domains are assigned to maintenance levels if this command is not issued.
Command Modes Global configuration (config)
Command History
Usage Guidelines When a router is in Ethernet CFM configuration mode, parameters specific to a maintenance domain can
be set. Several domains, with different names, can be configured at the same maintenance level; however,
a single domain cannot be associated with multiple levels.
In CFM IEEE, if a domain name has more than 43 characters, a warning message is displayed notifying
that the maintenance domain ID (MDID) will be truncated to 43 characters in continuity check messages
(CCMs) if “id <fmt> <MDID>” is not configured.
When this command places the CLI in Ethernet configuration mode, in CFM D1 the mode prompt is
“config-ether-cfm” and in CFM IEEE the mode prompt is “config-ecfm.
domain-name String of a maximum of 154 characters that identifies the domain.
level-id Integer from 0 to 7 that identifies the maintenance level.
Release Modification
12.2(33)SRA This command was introduced.
12.4(11)T This command was integrated into Cisco IOS Release 12.4(11)T.
The direction outward keywords were added.
12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.
12.2(33)SXI2 This command was integrated into Cisco IOS Release 12.2(33)SXI2.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was replaced with the ethernet cfm global command in
Cisco IOS Release 15.0(1)MR.
Page view 108
1 ... 108 109 110 ... 710

Comments to this Manuals

No comments