-129
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR
ethernet cfm traceroute cache hold-time
ethernet cfm traceroute cache hold-time
To set the time that Ethernet connectivity fault management (CFM) traceroute cache entries are retained,
use the ethernet cfm traceroute cache hold-time command in global configuration mode. To remove
the configured time, use the no form of this command.
ethernet cfm traceroute cache hold-time minutes
no ethernet cfm traceroute cache hold-time
Syntax Description
Command Default Entries are retained for 100 minutes.
Command Modes Global configuration (config)
Command History
Usage Guidelines Before you can issue this command, you must have enabled traceroute caching using the ethernet cfm
traceroute cache command.
If traceroute cache is enabled and not empty and you change the hold time to less than the currently
configured time, the change is rejected. You are prompted to clean up the table before the new hold time
can be accepted. For example:
Router(config)# ethernet cfm traceroute cache hold-time 5
Please clean up the cache before setting smaller hold-time
current hold time = 100 Command Aborted.
Router(config)#
Output of the show running all command displays “ethernet cfm traceroute cache hold-time 100” when
traceroute cache is enabled and the default value of 100 is configured.
Examples The following example shows how to set the retention time for entries in an Ethernet CFM traceroute
cache table to 5 minutes:
Router(config)# ethernet cfm traceroute cache hold-time 5
minutes Integer in the range of 1 to 65535 that specifies the number of minutes that
cache entries will be retained. The default is 100.
Release Modification
12.2(33)SRA This command was introduced.
12.4(11)T This command was integrated into Cisco IOS Release 12.4(11)T.
12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.
12.2(33)SXI2 This command was integrated into Cisco IOS Release 12.2(33)SXI2.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
Comments to this Manuals