Cisco MWR 2941 Installation Manual Page 545
- Page / 710
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
-545
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR
show ip mroute
show ip mroute
To display the contents of the multicast routing (mroute) table, use the show ip mroute command in user
EXEC or privileged EXEC mode.
Note The Cisco MWR 2941 only supports multicast routing for PTP redundancy. For more information, see
the Cisco MWR 2941-DC Mobile Wireless Edge Router Software Configuration Guide.
show ip mroute [vrf vrf-name] [[active [kbps] [interface type number] | bidirectional | count
[terse] | dense | interface type number | proxy | pruned | sparse | ssm | static | summary] |
[group-address [source-address]] [count [terse] | interface type number | proxy | pruned |
summary] | [source-address group-address] [count [terse] | interface type number | proxy |
pruned | summary] | [group-address] active [kbps] [interface type number]]
Syntax Description vrf vrf-name (Optional) Filters the output to display only the contents of the mroute table
that pertain to the Multicast Virtual Private Network (MVPN) routing and
forwarding (MVRF) instance specified for the vrf-name argument.
active kbps (Optional) Displays the rate that active sources are sending to multicast
groups, in kilobits per second (kbps). Active sources are those sending at the
kbps value or higher. The range is from 1 to 4294967295. The kbps default
is 4 kbps.
interface type number (Optional) Filters the output to display only mroute table information related
to the interface specified for the type number arguments.
bidirectional (Optional) Filters the output to display only information about bidirectional
routes in the mroute table.
count (Optional) Displays statistics about the group and source, including number
of packets, packets per second, average packet size, and bytes per second.
terse (Optional) Filters the output to display a subset of mroute statistics,
excluding source and group statistics for each mroute entry in the mroute
table.
dense (Optional) Filters the output to display only information about dense mode
routes in the mroute table.
proxy (Optional) Displays information about Reverse Path Forwarding (RPF)
vector proxies received on a multicast router.
pruned (Optional) Filters the output to display only information about pruned routes
in the mroute table.
sparse (Optional) Filters the output to display only information about sparse mode
routes in the mroute table.
ssm (Optional) Filters the output to display only the Source Specific Multicast
(SSM) routes in the mroute table.
static (Optional) Filters the output to display only the static routes in the mroute
table.
summary (Optional) Filters the output to display a one-line, abbreviated summary of
each entry in the mroute table.
- Release 15.1(3)MR 1
- Configuring a Policy Map 14
- Restrictions 15
- Policy Map Configuration Mode 27
- Class Characteristics 27
- Predefined Default Class 27
- Tail Drop or WRED 27
- Fragments 28
- If ID Choice Is Anything Else 72
- Unique Device Identifier 73
- Cisco HWIC-4SHDSL 88
- SNAP Encapsulation Example 96
- OL-26895-01 105
- • n393—1 to 10. Default is 4 133
- • proxy-register 187
- • list access-list 187
- • route-map map-name 187
- Support for Serial Lines 194
- Syntax Description 195
- Keepalive Time Interval 203
- Line Failure 203
- Dropped Packets 203
- DSCP Values 226
- Match Packets on DSCP Values 227
- • match access-group 231
- • match input-interface 231
- • match mpls experimental 231
- • match protocol 231
- Precedence Values and Names 233
- IPv4-Specific Traffic Match 233
- IPv6-Specific Traffic Match 234
- Support Restrictions 237
- ATM Mode Example 247
- CAS Mode Example 247
- Router(config)# no mpls ip 250
- Release 12.2(33)SRB 259
- • QL-PRC 275
- • QL-SSU-A 275
- • QL-SSU-B 275
- • QL-SEC 275
- • QL-DNU 275
- All Supported Platforms 303
- Hierarchical Policy Maps 304
- How Bandwidth Is Calculated 305
- • conform-action is transmit 311
- • exceed-action is drop 311
- • violate-action is drop 311
- Token Buckets 314
- Updating Token Buckets 315
- Marking Traffic 315
- Two-Rate Policing 316
- Syntax for Percent 318
- Command Application 332
- • Data encapsulation type 334
- • Control protocol 334
- • 4—1 packet every 16 seconds 336
- • 3—1 packet every 8 seconds 336
- • 2—1 packet every 4 seconds 336
- • 1—1 packet every 2 seconds 336
- • 0—1 packet every second 336
- Command Description 341
- Router(config)# exit 358
- Weighted Fair Queueing 366
- • Control network loops 376
- • Handle link failures 376
- • Improve convergence time 376
- the following adapters: the 409
- to specify the “from-field” 412
- • EF (expedited forwarding) 420
- Precedence Value and Queueing 421
- 2. ip tos reflect 429
- 3. ip tos tos-value 429
- Command Compatibility 440
- Bit Settings 440
- Precedence Value 441
- Committed Information Rate 449
- IMA Group 456
- M-PAIR Group 456
- 1-PAIR and 2-PAIR Group 456
- DSL Group with 1 Pair 458
- DSL Group with 2 Pairs 458
- DSL Group with 3 Pairs 458
- DSL Group with 4 Pairs 458
- • Interface name and number 471
- • Identifier (group ID) 475
- ADSL: Example 490
- • Domain name 495
- • Domain index 495
- • Domain level 495
- Field Description 504
- Reliability Errors 524
- Protocol Errors 524
- UNI Id Identifier of the UNI 526
- EVC Id Identifier of the EVC 526
- • Local and remote OAM mode 528
- • Remote platform identity 528
- • Remote loopback events 531
- Traffic Policing: Example 583
- Tunnel Marking: Example 588
- ATM Shared Port Adapter 590
- (continued) 595
- Policing 597
- Policing and Shaping 599
- Traffic Shaping: Example 600
- UDP encapsulation 613
- • priority is 128 647
- Router(config-if)# 648
- • Up to 2 queues 670
- • Up to 2 interfaces 670
- • 1 queue and 1 interface 670
- Router(config-if)# switchport 672
- GRE Tunneling Example 693
- Peak Value 705
- Average Value 705
- Burst Value 705
- Activating the Primary Member 709
- Activating the Backup Member: 709
Related products and manuals for Networking Cisco MWR 2941
Networking Cisco WMP110 User Manual
(2 pages)
(2 pages)
Networking Cisco Ex SERIES User Manual
(15 pages)
(15 pages)
Networking Cisco Soho series User Manual
(4 pages)
(4 pages)
Networking Cisco AS2509-RJ User Manual
(26 pages)
(26 pages)
Networking Cisco WKPC54G User Manual
(2 pages)
(2 pages)
Networking Cisco Dial NMS User Manual
(8 pages)
(8 pages)
Networking Cisco DMA2100 User Manual
(3 pages)
(3 pages)
(2 pages)© 2020, manymanuals.com. All rights reserved. | 0.124 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals