Cisco MWR 2941 Installation Manual Page 162

  • Download
  • Add to my manuals
  • Print
  • Page
    / 710
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 161
-162
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR
ethernet oam remote-loopback (interface)
ethernet oam remote-loopback (interface)
To enable the support of Ethernet operations, maintenance, and administration (OAM) remote loopback
operations on an interface or set a remote loopback timeout period, use the ethernet oam
remote-loopback (interface) command in interface configuration mode. To disable support or remove
the timeout setting, use the no form of this command.
ethernet oam remote-loopback {supported | timeout seconds}
no ethernet oam remote-loopback {supported | timeout}
Syntax Description
Command Default Remote loopback is not supported.
Command Modes Interface configuration (config-if)
Command History
Usage Guidelines This command enables the support of OAM remote-loopback on an interface. Only after this
functionality is enabled can the local OAM client initiate the OAM remote loopback operation. Changing
this setting causes the local OAM client to exchange configuration information with its remote peer.
The no form of the command is rejected if the interface is in the loopback mode.
Note To start Ethernet OAM remote loopback on a switch port, you must first configure the
access-group mode prefer port command in interface configuration mode.
Examples The following example shows how to enable remote loopback support on interface GigabitEthernet 2/1:
Router(config)# interface gigabitethernet 2/1
Router(config-if)# ethernet oam remote-loopback supported
supported Supports the remote loopback functionality.
timeout Sets a master loopback timeout setting.
seconds Integer from 1 to 10 that is the number seconds of the timeout period.
Release Modification
12.2(33)SRA This command was introduced.
12.4(15)T This command was integrated into Cisco IOS Release 12.4(15)T.
12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
Page view 161
1 ... 161 162 163 ... 710

Comments to this Manuals

No comments