Cisco MWR 2941 Installation Manual download pdf (Page 569)

100

101

-569

Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR

OL-26895-01

Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR

show mpls l2transport vc

Usage Guidelines If you do not specify any keywords or arguments, the command displays a summary of all the VCs.

Examples The output of the commands varies, depending on the type of Layer 2 packets being transported over the

AToM V C s.

The following example shows information about the interfaces and VCs that have been configured to

transport various Layer 2 packets on the router:

Router# show mpls l2transport vc

Local intf Local circuit Dest address VC ID Status

------------- ------------------ --------------- ---------- ----------

AT4/0 ATM AAL5 0/100 10.0.0.1 100 UP

AT4/0 ATM AAL5 0/200 10.0.0.1 200 UP

AT4/0.300 ATM AAL5 0/300 10.0.0.1 300 UP

12.2(17d)SXB Support for this command on the Supervisor Engine 2 was extended to

Release 12.2(17d)SXB.

12.2(25)S This command was updated with new output and fields for nonstop forwarding

(NSF), stateful switchover (SSO), and graceful restart (GR) abilities.

12.2(28)SB This command was implemented on the Cisco 10000 series routers. Example

output was changed for the Cisco 10000 series router, and two fields (SSO

Descriptor and SSM segment/switch IDs) were removed from the output, because

they are not supported.

12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.

12.2(33)SRB This command was updated to include forwarding equivalence class (FEC) 129

signaling information for pseudowires that are configured through VPLS

Autodiscovery, and to support provisioning Any Transport over MPLS (AToM)

static pseudowires.

12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.

12.2(33)SRC This command was updated to display the number of MAC address withdrawal

messages sent and received as part of the H-VPLS N-PE Redundancy for QinQ and

MPLS Access feature.

This command was updated to display pseudowire status between peer routers that

have been configured for the MPLS Pseudowire Status Signaling feature.

12.4(19)MR2 This command was integrated into Cisco IOS Release 12.4(19)MR2.

12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.

15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.

Release Modification

1 ... 568 569 570 ... 710

Comments to this Manuals

No comments

Cisco MWR 2941 Installation Manual Page 569

Comments to this Manuals

Related products and manuals for Networking Cisco MWR 2941