Cisco MWR 2941 Installation Manual Page 147

  • Download
  • Add to my manuals
  • Print
  • Page
    / 710
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 146
-147
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR
ethernet oam link-monitor frame-seconds
ethernet oam link-monitor frame-seconds
To configure a frame-seconds period on an Ethernet operations, maintenance, and administration (OAM)
interface, use the ethernet oam link-monitor frame-seconds command in configuration template and
interface configuration mode. To remove the threshold or window, use the no form of this command.
ethernet oam link-monitor frame-seconds {threshold {high {none | high-frames} | low
low-frames} | window milliseconds}
no ethernet oam link-monitor frame-seconds {threshold {high | low} | window}
Syntax Description
Command Default The ethernet oam link-monitor frame-seconds command is not configured.
Command Modes Configuration template (config-template)
Interface configuration (config-if)
Command History
Usage Guidelines The ethernet oam link-monitor frame-seconds command configures a number of error frames that
triggers an action or a period of time in which error frames are counted.
threshold Sets a number at, above, or below which an action is triggered.
high Sets a high error frame-seconds threshold in number of seconds.
none Disables a high threshold.
high-frames Integer in the range of 1 to 900 that is the high threshold in number of frames.
There is no default. The high threshold must be configured.
low Sets a low error frame-seconds threshold in number of seconds.
low-frames Integer in the range of 1 to 900 that sets the low threshold in number of
frames. The default is 1.
window Sets a polling window during which error frames are counted.
milliseconds Integer in the range of 100 to 9000 that represents a number of milliseconds
in a multiple of 100. The default is 1000.
Release Modification
12.2(33)SRA This command was introduced.
12.4(15)T This command was integrated into Cisco IOS Release 12.4(15)T.
12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
Page view 146
1 ... 146 147 148 ... 710

Comments to this Manuals

No comments