Cisco MWR 2941 Installation Manual download pdf (Page 675)

100

101

-675

Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR

OL-26895-01

Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR

switchport mode

To set the interface type, use the switchport mode command in interface configuration mode. Use the

appropriate no form of this command to reset the mode to the appropriate default mode for the device.

switchport mode {access | dot1q-tunnel | dynamic {auto | desirable} | trunk}

no switchport mode

Syntax Description

Command Default The default setting is dynamic auto.

Command Modes Interface configuration

Command History

Usage Guidelines

Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers

If you enter a forced mode, the interface does not negotiate the link to the neighboring interface. Ensure

that the interface ends match each other.

The no form of the command is not supported on the Cisco 2600 series, Cisco 3600 series, and

Cisco 3700 series routers.

Cisco Catalyst 6500/6000 Switches and Cisco 7600 Series Routers

If you enter access mode, the interface goes into permanent nontrunking mode and negotiates to convert

the link into a nontrunk link even if the neighboring interface does not agree to the change.

access Sets a nontrunking, nontagged single VLAN Layer 2 interface.

dot1q-tunnel Sets the trunking mode to TUNNEL unconditionally.

dynamic auto Sets the interface to convert the link to a trunk link.

dynamic desirable Sets the interface to actively attempt to convert the link to a trunk link.

trunk Specifies a trunking VLAN Layer 2 interface.

Release Modification

12.0(7)XE This command was introduced on the Cisco Catalyst 6000 family switches.

12.1(1)E This command was integrated on the Cisco Catalyst 6000 family switches.

12.1(8a)EX The switchport mode private-vlan {host | promiscuous} syntax was added.

12.2(2)XT Creation of switchports became available on Cisco 2600 series, Cisco 3600 series,

and Cisco 3700 series routers.

12.2(8)T This command was integrated into Cisco IOS Release 12.2(8)T for creation of

switchports on Cisco 2600 series, Cisco 3600 series, and Cisco 3700 series routers.

12.2(14)SX Support for this command was introduced on the Supervisor Engine 720.

12.2(17d)SXB Support for this command on the Supervisor Engine 2 was extended to Cisco IOS

Release 12.2(17d)SXB.

15.0(1)MR This command was integrated into 15.0(1)MR.

1 ... 674 675 676 ... 710

Comments to this Manuals

No comments

Cisco MWR 2941 Installation Manual Page 675

Comments to this Manuals

Related products and manuals for Networking Cisco MWR 2941