Cisco MWR 2941 Installation Manual Page 124

  • Download
  • Add to my manuals
  • Print
  • Page
    / 710
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 123
-124
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR
ethernet cfm mip
ethernet cfm mip
To globally provision maintenance intermediate points (MIPs) at a specified maintenance level for
VLAN IDs that are not associated with specific maintenance associations (MAs) and to enable level
filtering, use the ethernet cfm mip command in global configuration mode. To remove a MIP, use the
no form of this command.
ethernet cfm mip {auto-create level level-id vlan {vlan-id | vlan-id-vlan-id | ,vlan-id-vlan-id}
[lower-mep-only] [sender-id chassis] | filter}
no ethernet cfm mip {auto-create level level-id vlan {vlan-id | vlan-id-vlan-id | ,vlan-id-vlan-id}
[lower-mep-only] [sender-id {chassis | manage | chassis-manage}] | filter}
Syntax Description
Command Default MIPs are not provisioned.
Command Modes Global configuration (config)
Command History
auto-create Dynamically creates a connectivity fault management (CFM) MIP.
level Specifies a maintenance domain level.
level-id Integer from 0 to 7 that identifies the maintenance level.
vlan Indicates a VLAN for configuration.
vlan-id Integer from 1 to 4094 that identifies the VLAN to be configured.
vlan-id-vlan-id Integers from 1 to 4094 that define a range of VLANs to be configured.
The hyphen is required to separate the starting and ending VLAN ID
values that are used to define the range of VLAN IDs.
,vlan-id-vlan-id Integers from 1 to 4094 that define a range of VLANs to be configured.
The comma is required to separate VLAN ranges.
lower-mep-only (Optional) Creates a MIP only if a MEP is configured at the next lower active
maintenance domain level for the VLAN ID on the port.
sender-id (Optional) Configures the Sender ID option to send for VLAN IDs that are
not associated with specific maintenance associations.
If the sender-id option is not configured, the Sender ID TLV is not included
in messages.
chassis (Optional) Sends the chassis ID.
filter Configures a CFM MIP filter that drops all CFM frames at a lower level
independent of whether they come from the wire or relay function side.
Level filtering is disabled by default.
Release Modification
12.2(33)SXI2 This command was introduced.
Page view 123
1 ... 123 124 125 ... 710

Comments to this Manuals

No comments