-302
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR
police (percent)
police (percent)
To configure traffic policing on the basis of a percentage of bandwidth available on an interface, use the
police command in policy-map class configuration mode. To remove traffic policing from the
configuration, use the no form of this command.
police cir percent percentage [burst-in-msec] [bc conform-burst-in-msec ms]
[be peak-burst-in-msec ms] [pir percent percentage] [conform-action action [exceed-action
action [violate-action action]]]
no police cir percent percentage [burst-in-msec] [bc conform-burst-in-msec ms]
[be peak-burst-in-msec ms] [pir percent percentage] [conform-action action [exceed-action
action [violate-action action]]]
Syntax Description cir Committed information rate. Indicates that the CIR will be used for policing
traffic.
percent Specifies that a percentage of bandwidth will be used for calculating the
CIR.
percentage Specifies the bandwidth percentage. Valid range is a number from 1 to 100.
burst-in-msec (Optional) Burst in milliseconds. Valid range is a number from 1 to 2000.
bc (Optional) Conform burst (bc) size used by the first token bucket for policing
traffic.
conform-burst-in-msec (Optional) Specifies the bc value in milliseconds. Valid range is a number
from 1 to 2000.
ms (Optional) Indicates that the burst value is specified in milliseconds.
be (Optional) Peak burst (be) size used by the second token bucket for policing
traffic.
peak-burst-in-msec
(Optional) Specifies the be size in milliseconds. Valid range is a number
from 1 to 2000.
pir (Optional) Peak information rate. Indicates that the PIR will be used for
policing traffic.
percent (Optional) Specifies that a percentage of bandwidth will be used for
calculating the PIR.
conform-action (Optional) Action to take on packets whose rate is less than the conform
burst. You must specify a value for peak-burst-in-msec before you specify
the conform-action.
exceed-action (Optional) Action to take on packets whose rate is within the conform and
conform plus exceed burst.
Comments to this Manuals