Cisco MWR 2941 Installation Manual Page 240

  • Download
  • Add to my manuals
  • Print
  • Page
    / 710
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 239
-240
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR
mep archive hold-time
mep archive hold-time
To set the amount of time, in minutes, that data from a missing maintenance end point (MEP) is kept in
the continuity check database or that entries are held in the error database before they are purged, use
the mep archive-hold-time command in Ethernet connectivity fault management (CFM) configuration
mode. To restore the default number of minutes, use the no form of this command.
mep archive-hold-time minutes
no mep archive-hold-time minutes
Syntax Description
Command Default The command is enabled, and the archive hold time is set to 100 minutes.
Command Modes
CFM IEEE 802.1ag Standard (CFM IEEE)
Ethernet CFM configuration (config-ether-cfm)
Command History
Usage Guidelines When you reset the archive hold time, the new hold time applies only to entries in the database that occur
after the reset. Entries made before the hold time was reset are not affected by the change.
Different archive hold times can be set for MEPs in different domains.
Note A missing MEP is a remote MEP that sends a 0 expiration time in its continuity check or a remote
MEP whose entry in the local continuity check database expires after it exceeds its lifetime.
In CFM IEEE, output of the show running all command displays “mep archive hold-time 100” when
the default value is configured.
minutes Integer from 1 to 65535 that specifies the number of minutes that data from
a missing MEP is kept before it is purged. The default is 100.
Release Modification
12.2(33)SRA This command was introduced.
12.4(11)T This command was integrated into Cisco IOS Release 12.4(11)T.
12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.
12.2(33)SXI2 This command was integrated into Cisco IOS Release 12.2(33)SXI2.
In this release the command is supported only in CFM IEEE.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR. This
release does not support the Cisco pre-standard CFM Draft 1 (CFM D1).
Page view 239
1 ... 239 240 241 ... 710

Comments to this Manuals

No comments