Cisco MWR 2941 Installation Manual download pdf (Page 269)

100

101

-269

Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR

OL-26895-01

Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR

network-clock input-source

To select an interface or external timing input as a clock source and set a priority for the clock, use the

network-clock input-source command in configuration mode. To remove a clock source, use the no

form of this command.

network-clock input-source priority {interface interface-name slot/card/port | external [2m |

10m] | controller [BITS | E1 slot/port]}

no network-clock input-source priority {controller BITS | E1} | {interface type slot/card/port]

{external 2m | 10m}}

Syntax Description

Command Default None

Command Modes Global configuration (config)

Command History

Usage Guidelines During clock selection, the router considers clock sources according to their priority value.

Examples This example shows how to specify an input clock source:

Router(config)# network-clock input-source 5 10m

Router(config)#

priority The priority of the clock source. The range is from 1 to 250.

interface Specifies the interface connected to the clock input.

interface-name The name of the interface connected to the clock input.

slot The slot of Router/Switch where the clock source is present.

card The bay in which card is inserted.

port The port of the card.

external Specifies an external interface.

2m Specifies the 2 MHz interface.

10m Specifies the 10 MHz interface.

controller Specifies the controller connected to the clock source.

e1 Specifies the E1 controller.

BITS Specifies the BITS controller.

Release Modification

15.0(1)MR This command was introduced.

1 ... 268 269 270 ... 710

Comments to this Manuals

No comments

Cisco MWR 2941 Installation Manual Page 269

Comments to this Manuals

Related products and manuals for Networking Cisco MWR 2941